Clearaudio UNIVERSAL Bedienungsanleitung Seite 6

Universal
9" / 12"
User manual / Bedienungsanleitung
2.)
To adjust the pivot of the tonearm Clearaudio recommends the clearaudio IEC alignment
gauge (Art. No.: AC005 / IEC; also available at www.analogshop.de).
Make sure that the distance from the spindle to the pivot point (center) of the tonearm (9 ") is
exact 222 mm (for Universal 12" = 295 mm). When moving the armboard in one or
another direction you can set the correct distance. After distance is adjusted, tighten the screws
of the armboard.
222 mm
Pic. 5a: Distance from spindle to pivot 222 mm / Universal 9"
295 mm
Pic. 5b: Distance from spindle to pivot 295 mm / Universal 12"
Adjustment of the tonearm height with VTA – Lifter:
Please follow hereby the user manual of the VTA – Lifter.
The height of the tonearm ist adjusted correct, if the upper side of the mounted cartridge is
parallel to the surface of the record (when the cartridge is lifted down).
Seite/Page 6  clearaudio electronic GmbH 2014