Clearaudio UNIVERSAL Bedienungsanleitung Seite 7

2.2 Universal tonearm without VTA-Lifter:
1.)
Tighten the mounting plate for the
tonearm base. Please take the delivered screws.
Feed the tonearm cable through the mounting plate and slide the tonearm feet through the
drilling of the mounting plate.
Pic. 7 Placing the tonearm
2.)
To adjust the pivot of the tonearm Clearaudio
recommends the clearaudio IEC alignment gauge
(Art. No.: AC005 / IEC; also available at
www.analogshop.de).
Make sure that the distance from the spindle to the
pivot point (center) of the tonearm is exact 222 mm
(Universal 9") or 295 mm (Universal 12").
When moving the armboard in one or another direction
you can set the correct distance. After distance is
adjusted, tighten the screw of the armboard.
Seite/Page 7
Universal
Pic. 6
Universal
tonearm with the screws onto the mounted
Pic. 8 Distance from spindle to the pivot (222 mm/ 295 mm)
9" / 12"
User manual / Bedienungsanleitung
Universal
tonearm without VTA-Lifter
295 mm
(Universal 12")
 clearaudio electronic GmbH 2014
222 mm
(Universal 9")