Clearaudio EMOTION SE Bedienungsanleitung Seite 9

The following instructions are for Emotion SE packages.
If you use a tonearm and / or cartridge from different manufacturer please follow the
instruction manual of the particular manufacturer.
3.1. Tonearm set – up
1.)
Satisfy Carbon
Take the
into the hole of the tonearm base at the right upper corner of
Emotion SE
the - turntable chassis. Please ensure that the
tonearm tube is parallel to the side edge of the chassis
turntable.
Tighten the tonearm only slightly with the provided allen
wrench and screws.
Before you finish the tonearm-set up, please proceed with the
cartridge set-up.
The correct height adjustment that is going to be used for the tonearm is depending on the
cartridge you install.
2.)
For the next steps, please mount your cartridge on your tonearm (optional as a package:
Satisfy Carbon
Clearaudio
Use the manufacturer's instruction manual during this installation procedure and follow the
appropriate instructions.
The headshell wires (cartridge connection leads) are colour coded according to the
international standard :
Colour code of the Satisfy Carbon tonearm wire:
Signal left channel (L+)
Signal ground left channel (L -)
Signal right channel (R+)
Signal ground right channel (R -)
Please pay attention on every step to avoid any damages to the cartridge!
Now adjust the tracking force of the cartridge.
Please follow the instructions according the manual of the cartridge you use.
If you are using a Clearaudio Moving Magnet cartridge you can adjust the tracking force or
the wiring of the tonearm (about 20 mN), by turning the tonearm`s counter weight on the
threaded bolt (backside view of the tonearm).
Page / Seite 8
-tonearm and slide first the signal cable and then the tonearm shaft
tonearm) . Please leave the stylus protector on the cartridge.
Emotion SE
Pic. 6: Set up of the tonearm

white
 blue
 red

green
 Clearaudio electronic GmbH 2013
User manual / Bedienungsanleitung