Clearaudio EMOTION SE Bedienungsanleitung Seite 12

Emotion SE
User manual / Bedienungsanleitung
Lift down the cartridge and place the diamond tip of the cartridge
on the reference point on the alignment gauge and make sure that
the edges of the tonearm tube and the cartridge are absolutely
parallel to the marking lines printed on the cartridge alignment
gauge.
For that adjustment it is necessary to take a look directly from the
top on the tonearm and the alignment gauge.
Pic. 10: Top view: cartridge body
aligned to the printed lines
If you have to change the position of the diamond tip you can unscrew the allen screw on
the top of the tonearm`s headshell and move the cartridge into the corresponding position.
Please make also sure that the leading edge of the cartridge is parallel to the marker
lines of the cartridge alignment gauge. Fix the right position through looking the headshell
screw on the top.
During final tonearm and cartridge installation, always take a look from the top
onto the alignment gauge, to avoid any parallax errors.
The installation is done correctly, when at the same time the
armtube is parallel to the marking lines on the gauge, the
diamond tip is on the reference point and the leading edge of the
cartridge is parallel to the lines on the gauge. Finally lock all
screws that had been involved during the adjustments.
Now you are ready for the anti-skating adjustment.
This also depends on the tracking force of the cartridge
and the diamond shape.
Pic. 11: Correct installation
After setting up the cartridge, please tighten the tonearm in its base to fix it in this position.
Page / Seite 11  Clearaudio electronic GmbH 2013