Baumer NE134 Betriebsanleitung Seite 36

NE134
Line 11
Line 12
Line 13
Line 14
Line 15
Line 16
Line 17
Line 21
Line 22
Line 23
Line 24
36
PC - Main counter (current counter)
P1 - Preset value 1
P2 - Preset value 2
SC - Start count
tot - Totalizer
b - Batch counter
SF - Scaling factor
The dash line indicates the end of the second programming field.
Switch to programming field 3 by pushing
Programming field 3
All functions and values as well as interface parameters conditioned
by the machinery are programmed here.
Each factory setting is marked as such by *.
Operating modes main counter
0 * Adding, final signal at P2, reset to SC
1 Subtracting, final signal at SC. If programming with automatic
reset (Line 23), it is effected at SC.
2 Subtracting, final signal at SC. If programming with automatic
reset (Line 23), it is effected at 0.
Preset mode
0 * Main counter with 2 presets (Step preset)
1 Main counter with 2 presets (P1 then as trailing preset)
2 Main counter with presets P2, batch counter with preset P1
Reset modes
0 * Main counter and batch counter with automatic reset
1 Main counter without, batch counter with automatic reset
2 Main counter with, batch counter without automatic reset
3 Main counter and batch counter without automatic reset
Decimal point for PC, P1, P2, SC, tot
0 * No decimal point
1 00000.0
2 0000.00
3 000.000
www.baumer.com
or .