Clamping / Changing The Abrasive Belt; Dust Extraction; Operation; Switching On And Off - Parkside PBF 400 A1 Bedienungs- Und Sicherheitshinweise

Start-up / Operation
Clamping / changing
the abrasive belt
RISK OF INJURy! Always un-
plug from the mains before working on the band file.
Loosen the clamping device for the abrasive belt
by moving the clamping lever
Fig. B). The abrasive belt
Slide the new abrasive belt
in the housing of the tool. Important: The direc-
tion of the arrow on the inside of the abrasive
belt and the housing of the tool must match.
11
Slip the abrasive belt
roller .
15
Push the clamping lever
ing position.
Manually adjusting the abrasive belt:
If the path of the belt does not straighten after
switching on, it may need to be adjusted manually.
To do so, turn the adjusting screw
abrasive belt is centred.
11
IMPORTANT: Be sure the abrasive belt
does not grind into the housing. Regularly
check the path of the belt and adjust with the
adjusting screw
7

Dust extraction

EXPlOSION HAZARD!
A special dust extractor must be used for explosive
dust / air mixtures.
FIRE HAZARD DUE TO SPARKING! Do not
use dust extraction (dust bag
grinding metal.
FIRE HAZARD! Fire hazard
when using electric devices with dust bag or con-
nected to a vacuum via dust extraction! Unfavourable
conditions, e.g. sparking - when grinding metal or
metal pieces in wood - wood dust inside the dust
bag (or inside the dust bag of the vacuum) can
spontaneously ignite. This can particularly occur if
the wood dust comes is mixed with paint particles
or other chemicals and the ground product is hot
10 GB/IE
forward (see
9
can be removed.
11
through the slot
11
over the rear and front
11
back into the start-
9
until the
7
11
if necessary (see Fig. C).
or vacuum) when
5
after long work periods. Therefore be sure to avoid
the ground materials and the device from overheat-
ing and always empty the dust bag resp. the dust
bag of the vacuum before taking breaks.
Wear a dust
mask!
Dust extraction by dust bag (see Fig. D):
Compress the handles of the wire ring on the
dust bag to make it larger.
5
Slip the dust bag
5
tion .
16
Uninstalling / removing the dust bag:
Compress the handles of the wire ring on the
dust bag to make it larger. Remove the dust
5
bag from the device.
5
Adapter for external extraction
Connecting:
Place the extraction adapter
the teeth fit into the designated notches. now
turn the extraction adapter
tighten.
Slide the hose of a reliable dust extractor (e.g.
workshop vacuum) onto the extraction adapter
.
10
Removal:
Pull the hose out of the dust extraction unit.
Turn the extraction adapter
wise and remove from the file.

Operation

Switching on and off

When operating the device you can select between
intermittent or continuous operation:
Switching on temporary operation:
Push the On / OFF switch
onto the adapter connec-
onto the file so
10
clockwise to
10
counter-clock-
10
.
4