Items Supplied; Safety Instructions - EINHELL BT-SP 1300 Originalbetriebsanleitung

Anleitung_BT_SP_1300_SPK1:_
GB
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
1. Layout
1 On/Off switch
2 Slide block
3 Push stick
4 Hand crank
5 Chip extractor
6 Parallel stop
7 Clamping lever
8 Mounting for planing knife cover
9 Setting knob for the chip depth
10 Workpiece support
11 Rubber foot
12 Planing knife cover
13 Feed table
14 Planing table
15 Blade adjustment block
16 Allen key
17 Wrench
18 Scale
19 Pointer
20 Thicknessing table
21 Knife
22 Latch
23 Knife block
24 Anti-kick claws
25 Knife cover plate
26 Tipping guard bar
27 Chip extractor adapter, 100 mm diameter
28 Chip extractor adapter, 35 mm diameter
29 Scale
30 Pointer
31 Locking knob
32 Locking knob
33 Locking knob
34 Securing screw chip extractor
35 Overload switch
12
02.09.2010 11:29 Uhr Seite 12

2. Items supplied

Plane
Assembly tool
Push stick
Slide block (2x)

3. Safety Instructions

The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
4. Important information
Always switch off the On/Off switch (1) and pull
the mains plug out of the socket before carrying
out any maintenance work or having the machine
serviced. (Fig. 1)
Check at regular intervals that the knife (21) and
latch (22) are firmly attached in the knife block
(23). (Fig. 15)
The knives (21) must not project more than a
maximum of 1.1 mm out of the knife block (23).
(Fig. 15)
Never remove the safety covers on the machine
except for servicing and repair work.
The safety covers must be intact at all times.
Each time you use the machine, first fasten and
secure the safety covers at the points provided.
Connect a dust extractor to the sawdust extractor
(5) if you use the machine in an enclosed area.
(Fig. 1)
Make sure that the anti-kick claws (24) work
correctly. (Fig. 13)
Always wear eye protection.
Never cut concavities, tenons or shapes.
This machine will provide the performance
described in these operating instructions if it is
correctly assembled, used, maintained and
repaired. The machine must be inspected at
regular intervals. Never use any defective parts,
including power cables. Damaged, missing, worn
and deformed parts must be replaced immediately.
Only qualified personnel are permitted to carry out