Silvercrest SKMP 1200 A1 Bedienungsanleitung Seite 10

RP90864 Küchenmaschine LB6 Seite 8 Montag, 15. Juli 2013 5:23 17
Beater 15: For medium to light dough/
batter, e.g. batter for (pan)cakes.
7. Fit the attachment into the appropriate
opening in the drive arm 1 from below.
When doing so, make sure that the little
lugs on the shaft of the attachment are
inserted into the crosswise slot of the
opening.
8. Press the attachment lightly in and turn
clockwise until it engages.
9. Press the unlock lever 6 and swing the
drive arm 1 down into the working
position.
The appliance is now ready to use.
Fitting the blender jug
Caution!
• Do not use the blender jug 12 and the
mixing bowl at the same time 16. This
might overload the appliance.
1. Press the unlock button 3 for the lid 2 to
the left.
2. Take the lid 2 off.
3. Position the blender jug 12 so that the
little nib points to the open padlock
symbol.
4. Turn the blender jug 12 clockwise until it
engages. The little nib is now pointing to
the closed padlock symbol.
8
6.2 Dismantle appliance
1. Press the unlock lever 6 and swing up
the drive arm 1.
2. To remove an attachment, press lightly in
again
anticlockwise slightly.
3. Remove the attachment.
4. To remove the splash guard 8, pull it
downwards. When doing so, first pull
the splash guard 8 down at the back
slightly.
5. Unlock the mixing bowl 16 by rotating
slightly in a clockwise direction.
:
12
6. Remove the mixing bowl 16.
7. Press the unlock lever 6 and swing the
drive arm 1 down into the working
position.
Removing the blender jug
1. Turn the blender jug 12 anti-clockwise
until that the little nib points to the open
padlock symbol.
2. Remove the blender jug 12.
3. Put the lid 2 back on.
6.3 Use the splash guard
You can add ingredients during mixing:
1. Reduce the speed to 1 - 2.
2. Lift the flap over the filling opening 9.
and unlock by turning
12
: