WARN PullzAll Installations- Und Bedienungsanleitung Seite 6

How the PullzAll Reacts to Load
Before using your WARN
PullzAll to pull or lift a load it is
capacity. The maximum pulling
important to understand how it
torque occurs when there is only
works. The major advantage
one layer of wire rope on the drum.
of the PullzAll is its handheld
As the layers of wire rope on the
convenience for performing
drum increase, the pulling power
numerous recreational and work
decreases. This is the basics of
tasks. Thinking through how you
mechanical advantage.
intend to use your PullzAll now
could save you a big headache
later.
Control of Your PullzAll
The PullzAll tool has an On/
Off power switch and is controlled
by a directional switch and a
variable speed trigger control.
The directional switch
provides control of the forward and
reverse rotation of the spooling
drum. Keep tension on the wire
Load Limiter
rope when winding in or out to
prevent "bird nesting" that can bind
will cause the load limiter to trip,
and entangle the wire rope causing
which interrupts the power to the
damage to it and the PullzAll.
motor. This prevents overheating
When you see the red paint on the
and potential motor damage. At
wire rope, do not spool out any
90% of pulling capacity the overload
further. Doing so, can cause the
indicator turns red. When 100%
wire rope to spool on the drum
of pulling capacity is reached the
in the wrong direction. This can
load limiter will cause the overload
damage the wire rope and fairlead.
indicator to fl ash red and the PullzAll
The direction selection arrow
motor to stop. When this occurs,
should always match the direction
release the load by spooling out. Do
of the wire rope when it is spooling
not attempt to apply the same load
in or out.
if the load limiter has tripped, as
this can be harmful to the unit. If the
load limiter fails to reset contact an
authorized service center.
trip, perform the following actions:
1) Reduce the weight of the load.
2) Increase the distance of the
anchor point.
The variable speed trigger
3) Rig a double line pull.
switch has two general modes of
operation:
For details: See "Rigging
1) Variable speed mode for fi ne
Techniques" section in this manual.
load positioning.
2) Full speed mode for long
distance.
WARN INDUSTRIES * THE BASIC GUIDE TO UTILITY PULLING
HOW THE PULLZALL WORKS
The PullzAll is rated by pulling
WARNING
Always keep
PullzAll and
pulling load in
sight during
pulling operation.
WARNING
Never spool out
past the red paint
on wire rope.
Exceeding the PullzAll capacity
NOTICE
The PullzAll
is controlled
by the variale
speed trgger
and direction
selection switch.
If the load limiter continues to
11
HOW THE PULLZALL WORKS
PullzAll Mechanics
It is important to understand that
the longer the pull, the more heat gets
created within the motor. Spooling
out the rope also generates heat. Let
the motor cool between pulls because
prolonged use without cooling the
PullzAll will damage the motor.
Run Time/Duty Cycle
The PullzAll is rated for
intermittent duty. It should not be
operated for long periods with the
motor at low RPMs. When the motor
approaches stall speed a very rapid
heat build up occurs which may
cause motor damage. Follow the
recommended run times and cooling
times in the table shown. If the unit
does not function after it is allowed to
cool, call a Warn authorized service
center.
WARN INDUSTRIES * THE BASIC GUIDE TO UTILITY PULLING
RUN TIME/DUTY CYCLE TABLE
LOAD 500 lbs. 1000 lbs.
(227 kg) (454 kg)
RUN 2 min 1 min
TIME
COOL 30 min 30 min
TIME
12