WARN PullzAll Installations- Und Bedienungsanleitung Seite 5

So, you have your WARN
PullzAll and you are ready to put it
to use.
This guide provides you
with a basic understanding of
your PullzAll and teaches you
the basics of proper pulling/
lifting techniques. Before we get
started, we must emphasize that
the information in this guide is
general in nature. Because no two
situations are alike, it would be
nearly impossible to review them
all. We will, however, provide you
with the general principles and
techniques to use this tool safely
and effectively. Then it is up to
you to take the time to analyze
the situation and apply the proper
technique.
Along with a little common
sense, the information laid out in
this guide can help you lift and
pull safely. Just remember to
think through each lifting or pulling
situation before you act.
To Go Prepared TM , the
following instructions will help you
understand the operation of the
PullzAll.
WARN INDUSTRIES * THE BASIC GUIDE TO UTILITY PULLING
UTILITY PULLING INTRODUCTION
WARNING
Never operate a
PullzAll without
reading or
understanding
the operator's
manual.
9
HOW THE PULLZALL WORKS
To begin, you should
familiarize yourself with
your PullzAll and each of its PullzAll at an angle, the fairlead acts
components:
to guide the wire rope onto the top
of the spooling drum. It minimizes
damage to the rope while it goes
1.
Motor The motor provides through the PullzAll mount.
torque to the gear train, which
turns the PullzAll drum and winds
the wire rope. convert the PullzAll motor torque
into a large pulling force. The gear
2.
Spooling Drum The PullzAll
train design makes it possible for
drum is the cylinder from which
the PullzAll to be light and compact.
the wire rope winds. The drum is
driven by the gear train and motor.
Its direction can be changed using device that automatically interrupts
the directional selector switch. The
the power whenever the circuit
wire rope unwinds off the top of
becomes overloaded. The ready/
the drum. overload indicator LED turns red
under extreme loads and fl ashes
3.
Wire Rope The rope's
red when maximum load has been
diameter and length are
exceeded.
determined by the PullzAll's load
capacity and design. Wrapped
around the PullzAll drum and fed
through the fairlead, the rope is
looped at the end to accept the
hook's clevis pin.
2.
4.
3.
WARN INDUSTRIES * THE BASIC GUIDE TO UTILITY PULLING
4.
Fairlead When using the
5.
Gear Train The reduction gears
6.
Load Limiter (not shown) Is a
1.
5.
10