Cleaning And Care; Removing/Replacing The Pouring Sieve - Silvercrest Kettle SWKD 3000 A1 Bedienungsanleitung

As soon as the water temperature falls below the set
temperature, the kettle heats up again automatical-
ly. The LED q of the currently selected temperature
setting blinks until the selected temperature has
been regained. Afterwards, it glows constantly
again.
After 30 minutes the kettle switches itself off. Two
signal tones sound. All LEDs extinguish.
Information
- At any time you can cancel the temperature main-
tenance of the water by pressing the On/Off
button e or the KEEP WARM button
- Once you lift the kettle from the base
appliance switches all functions off.
Note
Do not let the water stand in the kettle for longer
than is absolutely necessary. That would lead to
scale deposits. Pour away the water that is no
longer required.

Cleaning and Care

Danger
Do not open any part of the housing. There are no
user-serviceable elements inside. An open housing
increases the risk of receiving a potentially fatal
electric shock.
Under NO circumstances may the appliance
parts be immersed in water or other liquids!
Should residual liquid be on "live" parts during
use, there would be the risk of receiving a
potentially fatal electric shock.
Before cleaning the appliance, ....
• first disconnect the plug from the mains power
socket and allow the appliance to cool down.
• Clean all exterior surfaces and the power cable
with a slightly moist cloth. In all cases, dry the
appliance well before using it again.
• To clean the inside of the kettle, thoroughly rinse
it out with water and then pour the water away.
• Do not use detergents, abrasives or solvents.
These can damage the appliance.
In the event of scale deposits:
w . • Before descaling, remove the pourer sieve
, the (see chapter "Removing/replacing the pourer
y
sieve").
• Use a descaler designed for household appliances
(e.g. for coffee machines). Pay heed to the in-
structions given for the descaler.
• For the stainless steel container bottom, you can
use a suitable product from a specialist dealer.

Removing/replacing the pouring sieve

• Open the lid.
• Press the tab at the upper end of the pourer
sieve
pourer sieve to the inside.
• You can then lift the pourer sieve
of its holder.
• Clean the pourer sieve
dishcloth and under running water.
• After cleaning, insert the pourer sieve
above and then push it forward so that the tab
locks into place. Ensure that the pourer sieve
grips into the holder at the lower end and is
firmly seated.
• Should any scale deposits have set on the pourer
sieve
solution at a ratio of 6:1. The scale deposits will
dissolve themselves. Rinse the pourer sieve
with copious amounts of clear water.
- 6 -
down and, simultaneously, push the
i
i with a lightly moistened
, soak it for a few hours in a water-vinegar
i
i
up and out
i
from
i
i
i