Operation; Switching The Pump On; Switching The Pump Off - AL-KO GP 600 ECO Betriebsanleitung

Operation

6 OPERATION
6.1

Switching the pump on

1. Open all shut-off devices (valve, spray
nozzle, water cock) in the pressure line.
2. Insert the plug of the mains cable into the
power socket.
3. Switch on the pump at the on / off switch (4).
IMPORTANT!
Danger of damage to the
pump!
A closed pressure line can
result in damage to the
pump!
■
Do not allow the pump
to run against a closed
pressure line.
6.2

Switching the pump off

1. Switch the pump off at the on / off switch (4)
after use.
2. Close all the shut-off devices in the pressure
line.
469928_a
CAUTION!
Danger of injury from hot
water
After extended use against
the closed pressure side
(>10 min.), the water in the
pump can become very
hot and may escape un-
controlled!
■
Disconnect the pump
from the mains supply
and allow the pump and
water to cool down.
■
Put the pump into oper-
ation again only after all
the faults have been
remedied!
The risk of injury from hot water can arise in the
event of:
■
Incorrect installation,
■
Closed pressure side,
■
a lack of water in the suction line.
Procedure
1. Disconnect the pump from the mains supply
and allow the pump and water to cool down.
2. Check the pump, installation and water level.
3. Put the pump into operation again only after
all the faults have been remedied!
21