Audio; Aroma; Infrared; Programs - HOESCH SenseSation Montage- Und Bedienungsanweisung

04.04 Audio

In the submenu the items "Radio FM", "MP3/WMA" or "Aux In" can be controlled.
Radio: station-search run. Using and buttons you can set previous and next station respectively.
MP3/WMA: Firsty a corresponding storage device must be connected to the USB port in the wall installation profile.
Using and buttons you can select the previous and next music title respectively. Pressing [menu] button you can
enter the submenu, where "Next folder" and "Random selection" using [ok] button can be activated / deactivated.
AUX In: Connected, external signal sources can be controlled using a chich-connector. The volume is set using [-] and
[+] buttons.

04.05 Aroma

The function "Aroma" is activated / deactivated by pressing [OK] button in the main menu.
Using [menu] button you can enter the sub items "Aroma" (in %), "Fragrance dispencer"
and "Filling".
Pressing the fi rst sup item and using [+] and [-] buttons you can set the aroma's intensity
in intervals of ten between 10 % and 100 %. The factory default value is 100 %.
The fragrance dispencer is activated / deactivated using [ok] button. Through these you
GB
can enjoy the desired aroma even without the steam function.
Before you activate the fi lling, please ensure that the suction hose is placed in the
appropriate recervoir with aroma. As soon as you activate the fi lling using [ok] button, the
process starts. Filling stops automatically, as soon as the internal sensor signs fully fi lled
aroma recevoir.

04.06 Infrared

The function infrared (IR) is activated / deactivated in the main menu using [OK] button.
In the submenu of this function you can set the "IR-intensity" and the "IR-duration".
The IR-intensity is adjusted by means of different intensity levels and ranges between 1 (low intensity) and 6 (high
intensity). The selection of the appropriate intensity occurs via [+] and [-] buttons.
The adjustment range of the IR-duration is between 0 and 90 minutes. The adjustment occurs via [+] and [-] buttons in 5
minute increments.

04.07 Programs

You can program four different programs (program 1-4) in "Programs" subsection in the main menu.
By pressing [menu] button you select eg. "program 1" and can program the beginning and the end of your steam bath.
At the same time, you can set the fragrance function, if required.
You can select steam bath start up and fi nish time in 24 hours format by using [-] and [+] button.
Aromatherapy is turned on/off with [OK] button.
If one or more programs are active, and the control panel is switched into standby mode with button, the following
message appears: "Warning! Running programs are active".
16