Technical Data; Troubleshooting - EINHELL HGG 110 NIRO Bedienungsanleitung

Anleitung HGG 110 NIRO/170 NIRO

Technical Data

HGG 110 NIRO
Nominal heat load Qu: Max. (Hi) 11,2 kW
Air throughput: 500 m 3 /h
Connection: G 30: 815 g/h P/B
Type of gas: commercially available
propane (DIN 51622)
Commercially available
butane (DIN 51622)
Operating pressure P: 300 m bar
Mains power supply: 230 V ~ 50 Hz 38 W
Trouble Shooting
Problem Cause
Motor doesn't start No electricity
Piezo doesn't ignite Electrode incorrectly adjusted
No gas at burner - Gas valve is closed
- Gas cylinder is empty
- Gas hose or connection leaks
Burner ignites, flame is - The thermoelement was not
extinguished as soon as the gas - warm enough
valve is released - The safety thermostat
- - switches off
Burner goes out while in use - Gas flow too high
- Air input too low
Important!
Have repairs carried out only by specialist workshops or ISC.
15.06.2004 11:46 Uhr Seite 11
HGG 171 NIRO
Max. (Hi) 17 kW
500 m 3 /h
G 30: 1430 g/h P/B
commercially available
propane (DIN 51622)
Commercially available
butane (DIN 51622)
300 m bar
230 V ~ 50 Hz 38 W
Remedy
- Check electrical outlet
- Check mains cable
Check electrode and precisely
set according to diagram
- Open valve
- New gas cylinder
- Locate point of leak with soap
- foam and repair
- Repeat ignition procedure
- while pressing in the gas
- valve knob
- Allow the heater to cool for a
- few minutes and reignite
- Have the pressure regulator
- inspected and replace if
- necessary
- Check the suction grid and
- clean
- Inspect ventilator
GB
11