EINHELL HGG 110 NIRO Bedienungsanleitung Seite 9

Anleitung HGG 110 NIRO/170 NIRO
Starting Operation
Please observe all regulations
and guidelines governing the
safe use of liquid gas in your
area (in Germany, the technical
rules for liquid gas TRF 1988 as
well as the professional
association guidelines for the
use of liquid gas ZH 1/455)
when using the heater.
Follow the instructions listed
below in the order they are
presented.
1. Plug in the mains cable
(230 V ~ 50 Hz)
2. Screw-fasten flexible gas tube
with pressure reducer and
integrated tube rupture
protective device to the gas
valve (the tightness of the
screw couplings must be
ensured). Open the gas
cylinder valve.
2.1 Actuate the push button of
tube rupture protective device.
3. Press the ON-OFF switch.
Check by eye (from the air
inflow side) if the ventilator
motor is rotating.
4. Press the gas valve button and
simultaneously press the
ignition button repeatedly until
the burner ignites (only if the
ventilator is rotating).
5. To switch off the heater,
always first close the gas
cylinder valve and only then
turn off the ventilator motor.
15.06.2004 11:46 Uhr Seite 9
GB
Fuel
Commercially available propane
(DIN 51622)
Commercially available butane
(DIN 51622)
Pressure reducer 300 mbar
The appliance can be operated in
conjunction with any 5 kg or 11 kg
gas cylinder or an even bigger
container. Be sure to use only the
following equipment when
connecting the unit to a gas
cylinder: For model HGG 110
Niro/HGG 171 NIRO a pressure
reducer with an output pressure
of 300 mbar with DIN 4811 Part 1,
together with a liquefied gas pipe
in compliance with DK 6
according to DIN 4815 Part 2.
pressure reducer
9