Installation Instructions - Plamen Marina Anleitung

Marina is a product designed in accordance with current trends, featuring clean simple lines that fit
into any ambient style. The stove is made of high quality cast iron with colour-enamelled finish giving a
visually enhanced appearance to the product as a whole.
Large glazed door offers the view of the entire firebox and full experience of the open fire. Thanks to a
specific design of primary and secondary air supply, the glass remains clean throughout the heating
time. The stove is designed with a drawer at the bottom where a limited quantity of fuel and stove
accessories may be kept. Above the firebox, a „boiler" (heat exchanger) is installed. So, this stove can
be used as a direct room heater, as a part of a central heating system with radiators and for
preparation of hot water. The stove design ensures long-lasting ember bed and the fire needs not be
extinguished for several days
Please READ CAREFULLY THESE INSTRUCTIONS in order to achieve the best performance at the
very first use of the stove.
The stove meets all relevant EN 13 240 requirements and has a CE marking affixed to it.
TECHNICAL DATA:
MEASUREMENTS: W x H x D
WEIGHT:
RATED OUTPUT:
irect
d heating:
water heating:
ENERGY EFFICIENCY:
FLUE OUTLET:
FUEL:

INSTALLATION INSTRUCTIONS

Place the pan cover (111) into the firebox. The stove is delivered complete with a top mounted flue
connection.
A spring may be installed on the lower hinge of the stove door to make sure that the door will not
remain open, except when firing or refuelling. This makes it possible to connect more than one
appliance to a single chimney and, in case of a chimney of inadequate design and/or in poor
maintenance condition, prevents the smoke from spreading into the room.
To install the spring, proceed as follows:
Figure 1
- Open the door, remove the bolt from the lower hinge, remove the door and insert the pin with the
spring in prestressed position (see Figure 1). Reinsert the door on the upper bolt, insert the longer end
of the spring into the hole on the front frame and install the pin in the lower eye on the front frame
(103).
50x122,6x54 cm
164 kg
10,5kW
4,5kW
6kW
79,4%
Ø150 mm
Wood, wood briquettes
21