Technical Data; Installation Instructions - Plamen Vesta VE-101 Technische Anweisungen

Vesta is a product designed to suit current trends, distinguished by the simplicity of its modern
straight lines adaptable to any interior, made from quality gray iron, enameled in a shade that
lends the product a rich appearance.
Through a large glazed door the whole firebox can be seen, which provides a true hearthside
feeling. Owing to a specific primary and secondary air supply, the glass remains clean throughout
the stoking time. The stove can maintain fire for a long time, so need not be put out for more days.
We call upon you to CAREFULLY READ THESE INSTRUCTIONS, which will enable you to
achieve optimum results at the very first use.
In terms of quality the Stove meets the essential requirements of EN 13 240 and bears the
mark.

TECHNICAL DATA:

DIMENSIONS: W x H x L
WEIGHT:
NOMINAL OUTPUT:
POWER RANGE:
FLUE GAS DISCHARGE: back or top:
REAR DISCHARGE HEIGHT FROM
FLOOR TO MIDDLE:
HEATED SPACE:
FUEL:

INSTALLATION INSTRUCTIONS

From the firebox space, place the hopper lid (111).
The Stove is supplied with a flue gas extension installed on top. If required, it can also be installed
in the rear. In that case, free the opening on the rear shield (204) and exchange the places of the
flue gas extension (116) and the flue gas extension lid (118). With two M6 bolts and nuts tighten
and seal the junctions and close the cupola opening with the cupola lid (117).
On the stove door, a spring may be affixed to the lower hinge to ensure that the door cannot
remain open except for firing. This feature ensures that the same chimney can handle more
stoves and that with worse chimneys or greater fuel quantity flue gas will not escape into the
room.
Figure 1
For installing the spring, you should:
open the door, take out the bolt on the lower hinge, remove the door and place on it the spring-
fitted shaft so that the spring is pre-tensioned (see Figure 1). Force the door on to the upper bolt,
insert the longer end of the spring into the hole on the obverse and attach the shaft to the lower
ear on the obverse (103).
500x1065x515 mm
130 kg
7 kW
up to 12 kW
Ø150 mm
90,5 cm
3
up to 200 m
wood, wood briquettes
17