Operating System Updating; Factory Setting - Viscount MIDI-Pedalboard Bedienungsanleitung

EN Viscount MIDI-Pedalboard

6. OPERATING SYSTEM UPDATING

The operating system is supplied by Viscount as a Midi file (.mid file). For loading it into the Midi
pedalboard, you have to use a Midi data player and to connect its Midi out to the pedalboard's [INPUT 1]
(not INPUT 2). When loading the green Led will flash, after reception the instrument will check data. If
correct the green Led lights off and the red Led will flash one time. If not correct, the red Led will flsh as
follows:
- two flashes: data are lost
- three flashes: checksum is not correct
- four flashes: generic error
In this case load again the operating system file, check the quality of Midi cables and that Midi data
player doesn't generate errors.
For loading the operating system when Midi pedalboard is not on, switch it on pressing [SET] button and
red Led will flash one time.
If it is not possible to load data please contact a service center informing about the error occurred (how
many times the red Led has flashed).

7. FACTORY SETTING

The Factory Setting procedure allows you to restore the factory configuration of internal functions, deleting
all the changes made by the user. For doing it, keep pressed for 10 seconds [SET] button, when this
procedure is completed, the red Led fwill flashs twice.
Factory settings as follows:
- Midi transmission channel: 4
- Midi velocity of transmitted value: 64
- Note number of first pedal -C1: 36
- Program Change number of first pedal -C1: 1
- Midi transmission channel of expression pedal [EXPR. 1]: 2
- Midi transmission channel of expression pedal [EXPR. 2]: 1
- Control Change message of expression pedal [EXPR. 1]: 11 (Expression)
- Control Change message of expression pedal [EXPR. 2]: 11 (Expression)
- Pedalboard function mode: poly
20