Cleaning The Pump Filter; Maintaining Your Machine - Fagor FET-6412D Bedienungsanleitung

EN

5 / MAINTAINING YOUR MACHINE

• CLEANING THE PUMP FILTER

This filter collects the small objects you may have inadvertently left in your
clothes and prevents them from disrupting the pump's operation.
To clean the filter, proceed as follows:
— Open the drum doors. At the back of the drum, you will see a plastic
component (Diagram D20)
А
— Release this (Diagram D21.
To do this:
- Insert a rod (a pencil or a screwdriver, for example) into the hole in the
component .
А
- Press down vertically with the rod, while pushing the component over
to the right until it is released from its housing
— Remove the component
А
— Turn the drum slightly towards the front of the machine, with the doors
open (Diagram D22)
You can access the pump filter
the plastic component .
А
— Remove the filter from its housing (Diagram D22)
— Remove the various objects it may have in it
— Rinse it under the tap (Diagram D23)
— Re-insert it, pushing it firmly into its housing after checking that the
housing is clean
— Re-insert the plastic component
in the openings at the bottom of the drum and pushing it to the left until it is
fully engaged (Diagram D24).
• CLEANING THE MACHINE
Important:
To clean the casing, the control panel and all the plastic parts
in general, use a sponge or a soft cloth dampened only with water
and liquid soap.
In all cases, do not use:
— Abrasive powders
— Metal or plastic sponges
— Alcohol-based products (alcohol, thinners, etc.)
D 20
A
D 21
.
А
through the openings freed by removing
В
, ensuring that it is positioned correctly
А
D 22
• CARE OF THE INTERNAL COMPONENTS
To ensure better hygiene, we recommend that you:
— Leave the lid open for a short time after washing.
— Clean the plastic and rubber access components to the tank pproximately
once a month using a slightly chlorinated product. Run a rinsing cycle to
remove any residue of this product.
— Run a washing cycle at 90°C at least once a month.
• CLEANING THE PRODUCTS' BOX
Clean the products' box regularly.
To do this:
— Press the bosses on each side of the box simultaneously to extract it
С
from its housing (Diagram D25)
— Remove the siphon
D
from its front cover (Diagram D26)
F
— Rinse everything under the tap (taking care to empty any excess water
remaining inside the box)
— Refit all the box' components, ensuring that the box section itself is
properly clipped into the cover and then re-insert the complete assembly
into its location under the machine's lid.
• PERIODIC CHECKS
To avoid any water damage, we recommend that you regularly check the
condition of the water and drain hoses. If you notice the slightest cracking,
do not hesitate to replace the hoses with identical ones available from
the manufacturer or his After-Sales Service. For how to replace the water
supply hose, please refer to the section «CONNECTING TO THE COLD
WATER SUPPLY».
• REPLACING THE POWER SUPPLY CABLE
Warning:
For your safety, the power cable and, depending on the model,
the complete electric box and its associated cable must only be
replaced by the manufacturer's After-Sales Service or a qualified
electrician.
D 23
D 24
24
from the rear of the box and separate the box
E
D 25
D 26