Installation - Dimplex Kah 150 Montage- Und Gebrauchsanweisung

KAH 150
ATTENTION!
Before you start working, switch the unit off by disconnecting it from the
power supply.
1

Installation

1.1 Heat pump with interior
terminal box
1) Drill a Ø 16 mm hole for an additional cable gland into the
cover of the fan terminal box and attach the supplied strain
relief.
2) Install the supplied condensate drain heater (see Fig.1.1 on
pag. 1).
Fig. 1.1:
3) Route the connection line through the new cable gland into
the terminal box and attach the line to the fan braces using
the supplied cable ties.
4) Connect the line in parallel to the nozzle ring heater E4 (see
Fig.1.2 on pag. 1).
Fig. 1.2:
EN-1
If there are no spare terminal connection contacts, the supplied
cable connectors can be used for the affected lines (see Fig.1.3
on pag. 1).
Fig. 1.3:
5) Make the appropriate changes to the wiring diagrams.
452158.66.96 · FD 9202