Changing Presettings With The Control Panel - SOLTRON M-60 BALANCE POWER Gebrauchsanweisung

Changing presettings with the control panel

The setting mode enables you to call up operating states and make alter-
ations to current settings.
Changing to Presetting mode
– Press the buttons – and + simultaneously for at least five seconds
outside a tanning process.
appears in the display.
_ _ _ _
– Enter the code (see Page 120).
– Press the START/STOP button four times when you run the Preset-
ting mode for the first time.
When a Master or Studio Code is already set (see Page 120), one of
these codes must be entered.
briefly appears in the display, then the first function and the
- - - -
presetting value are displayed alternately (see column "On delivery").
– By pressing the + button you scroll up to the next function.
– By pressing the – button you scroll down to the next function.
Changing presettings
Increase the preset value:
– Press and hold the START/STOP button while simultaneously press-
ing the + button.
Decrease the preset value:
– Press and hold the START/STOP button while simultaneously press-
ing the – button.
Reset to the last value set:
– Press the START/STOP button.
Reset to the delivered state:
– See function 254.
Note:
The sunbed will automatically return to 'idle' mode 30 seconds
after the last button was pressed.
The presettings are listed beginning on Page 122.
119