Herunterladen Inhalt Inhalt Diese Seite drucken

Atag VA63211OT Benutzerinformation Seite 19

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Problem and alarm code
The remaining time in the dis-
play increases and skips
nearly to the end of program
time.
Small leak from the appliance
door.
The appliance door is difficult
to close.
Rattling/knocking sounds
from inside the appliance.
The appliance trips the cir-
cuit-beaker.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible causes.
Once you have checked the appliance,
deactivate and activate the appliance. If the
The washing and drying results are not satisfactory
Problem
Poor washing results.
Poor drying results.
Possible cause and solution
• This is not a defect. The appliance is working correctly.
• The appliance is not level. Loosen or tighten the adjustable
feet (if applicable).
• The appliance door is not centred on the tub. Adjust the rear
foot (if applicable).
• The appliance is not level. Loosen or tighten the adjustable
feet (if applicable).
• Parts of the tableware are protruding from the baskets.
• The tableware is not properly arranged in the baskets. Refer
to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneously all the
appliances in use. Check the socket amperage and the ca-
pacity of the meter or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Author-
ised Service Centre.
problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
Possible cause and solution
• Refer to "Daily use", "Hints and tips" and basket load-
ing leaflet.
• Use more intensive washing programmes.
• If you use multi-tablets, always switch on the option Multi-
tab.
• Clean spray arm jets and filter. Refer to "Care and
Cleaning".
• Tableware has been left for too long inside a closed appli-
ance.
• There is no rinse aid or the dosage of rinse aid is not
enough. Set the rinse aid dispenser to a higher level.
• Plastic items may need to be towel dried.
• We recommend to always use rinse aid, even in combina-
tion with multi-tablets.
19

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis