Using The Machine - Clatronic db 2879 Bedienungsanleitung

5....-05-DB 2879
• Clean the ironing base with a slightly damp cloth.
• Fill the water tank (8) through the filler aperture (6) with pure water (up to
degree of hardness 2). If the tap water is harder please use distilled water.
Place an empty vessel near the device.
NOTE: Only clothes should to be ironed with this machine.
Ironing without steam (steam jet regulator on 0)
1. Place the iron on its stand.
2. Turn the steam regulator (5) to 0.
3. Electrical connection
Make sure that the iron voltage (see name plate) and the line voltage match.
4. Sort out the garments according to their ironing temperatures. Start with the
lower temperatures. It is set with the thermostat (1):
• Synthetics, silk
• • Wool
• • • Cotton, linen
5. Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
6. The control lamp (2) lights up. As soon as it shuts off, the set temperature is
reached. Now you can start to iron.
7. Always pull the plug out of the socket after using the iron.
Steam Ironing
For this a high temperature is needed (cotton, linen).
The quantity of steam can be regulated using the steam quantity regulator (5).
1 Small steam volume
2 Medium steam volume
3 Large steam volume
Extra steam can be added with the steam jet function (4).
Caution: the steam is hot. Danger of scalding!
Note: When the steam regulator (5) is switched from a large steam volume to a
smaller one, the regulator automatically jumps to the 0 position.
When ironing at low temperatures, make sure that you reduce the quantity of steam
or iron without steam.
Spray Function ( )
In order to moisten a section to be ironed press the spray button (3).
24.03.2004 9:22 Uhr
First Use of the Machine

Using the Machine

(low temperature)
(medium temperature)
(high temperature)
Seite 33
GB
33