Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1 Temperature control
2 Steam-jet button
3 Fixing device
4 Connecting tube
5 Control lamp
6 Water tank
7 Lock/Filling aperture
for the water tank
8 Iron well
•
Clean the ironing base with a slightly damp cloth. Remove any foil from the
sole of the iron.
•
In order to remove all residues before initial use, please pass the iron a few
times over an old clean cloth.
•
Open the seal (7) of the water tank and fi ll it through the opening with not more
than 0.7 litres of pure distilled water. Then re-tighten the seal.
•
Do not fi ll battery water, water from the clothes dryer and water containing
additives (such as starch, perfume, softener or other chemicals) into the water
reservoir. This could damage the iron due to residues forming in the steam
chamber. These residues may cause impurities to the fabric when dropping out
of the holes in the soleplate.
Ironing without steam
GB
1. Sort out the garments according to their ironing temperatures.
2. Always turn the temperature control to the lowest temperature setting (before
the setting " ") before connecting the device to or disconnecting it from the
mains.
3. Start with the lower temperatures. It is set with the thermostat (1):
•
Synthetics, silk
• •
Wool
• • •
Cotton, linen
MAX
4. Place the iron on its stand.
5. Electrical connection:
•
Make sure that the iron voltage (see name plate) and the line voltage
match.
•
Only connect the machine to a properly installed safety socket,
230 V/50 Hz.
46
05-DBS 3000 NEW 46
Overview of the Components
First Use of the Machine
Using the Machine
9 Steam control
10 Operating switch I
(Boiler)
11 Operating switch II
(iron)
12 Control lamp (steam)
13 Control lamp
(water tank empty)
low temperature
medium temperature
high temperature
maximum temperature
06.04.2006, 8:03:13 Uhr
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
