General Description; Getting Ready; Filling With Water; Setting The Temperature - Bosch TDS 1506 Gebrauchsanleitung

• Caution: The steam hose, base station and
in particular the iron can get very hot when
used!!
This appliance has been designed exclusively
for domestic use and must not be used for
professional purposes.
A) Introduction
Thank you for buying the Professional Steam Stal l
tion sensixx B15L from Bosch. Please read these
instructions very well. They contain valuable inforl l
mation about the unique features of this system
and some hints to make the ironing easier.
This system produces non stop steam for an ideal
ironing performance. We hope you enjoy ironing
with this steam station.
B) General description
1. "Steam ready" pilot light
2. "Water empty" pilot light
3. Variable steam control dial
4. Main switch (STEAM IRON/off/DRY IRON)
5. Plastic cover of boiler plug
6. Boiler plug
7. Cord storage compartment / Automatic cable
rewind.
8. Cable rewind control button
9. Water inlet
10. Water tank
11. Steam release button
12. Temperature dial
13. Iron pilot light
14. Lock button for permanent steam
15. Steam hose
16. Iron stand
17. Water tank plug
C) Getting Ready
1. Remove any label or protective covering from
the sole plate.
2. Place the appliance on a stable level surface.
D) Filling with water.
1. Switch the main switch (4) to the OFF position
and remove the mains plug from the wall socket
before filling the water tank.
2. Open the water inlet lid (9).
3. Use the provided beaker to fill the tank with
water.
4. Fill the tank with water until the MAXlmark.
Important
• Normal tap water can be used. If the water in
your region is very hard we advise you to mix it
with an equal amount of distilled or demineralil l
sed water. This will prolong the optimal steam
function of the steam station. You can inquire
about the water hardness with your local water
supplier.
• Never use distilled water exclusively
• To avoid any damage and or contamination of
the system, do not put in any perfume, vinegar,
starch or other type of chemical into the water
tank.
• Do not use condensation water from tumble
dryers, fridges or the like.
E) Setting the temperature
1. Check the ironing instruction label on the
garment to determine the correct ironing teml l
perature
2. Place the iron on the iron stand (16).
3. Insert the mains plug into the mains supply and
then set the main switch (4) either to the DRY
IRON or STEAM IRON
4. Select the right temperature on the iron by
rotating the temperature dial (12)
• Synthetics
•• Silk/Wool
••• Cotton / Linen
5. The steam function ready light will flash during
heating up taking approximate 2 – 3 minutes.
(For first time use, the pre-heating time can
be 4 minutes.)
Tips:
• Sort your garments out based on their cleaning
symbol labels. Always starting ironing with clothes
en
position.
11