Troubleshooting - Zanussi ZWF 1211 Benutzerhandbuch

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
INTRODUCTION
The start of the appliance does not occur or it
stops during operation.
First try to find a solution to the problem (refer to
the table). If not, contact the Authorised Service
Centre.
With some problems, the acoustic signals operate.
The indicator of button
of the indicators comes on, to show an alarm code:
• - The appliance does not fill with water
properly.
• - The appliance does not drain the water.
• - The appliance door is open or not closed
correctly. Please check the door!
If the appliance is overloaded,
remove some items from the drum
and/or keep pressed the door and
push the
time until the indicator
flashing (see the picture below).
POSSIBLE FAILURES
Problem
The programme does not
start.
flashes in red and one
button at the same
stops
• Make sure that the mains plug is connected to the mains socket.
• Make sure that the appliance door is closed.
• Make sure that there is not a damaged fuse in the fuse box.
• Make sure that the Start/Pause has been pressed.
• If the delay start is set, cancel the setting or wait for the end of
countdown.
• Deactivate the Child Lock function if it is on.
5. When no more water flows, install the inlet
hose and the drain hose again.
WARNING! Make sure that the
temperature is more than 0 °C before
you use the appliance again. The
manufacturer is not responsible for
damages caused by low temperatures.
• The indicator of button
times and 1 (or 2 or 3) time(s) in yellow: The
mains supply is unstable. Wait until the mains
supply is stable.
WARNING! Deactivate the appliance
before you do the checks.
Possible solution
flashes in red 11
15