Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Remove the drain hose from the rear support
and unhook it from sink or spigot.
4. Put the ends of the drain and inlet hose in a
container. Let the water flow out of the hoses.
5. Set any selected programme with option
Pumpen/ Vidange Schleudern/ Essorage and
let it operate until the end of the cycle.
6. When no more water flows, install the inlet
hose and the drain hose again.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
INTRODUCTION
The appliance does not start or it stops during
operation.
First try to find a solution to the problem (refer to
the table). If the problem persists, contact the
Authorised Service Centre.
With some problems, the acoustic signals
operate and the display shows an alarm
code:
•
- The appliance does not fill with water
properly.
POSSIBLE FAILURES
Problem
The programme does not
start.
The appliance does not fill
with water properly.
18
7. Press the Ein/Aus Marche/Arrêt button to
•
•
•
•
•
Make sure that the mains plug is connected to the mains socket.
•
Make sure that the appliance lid and drum doors are closed proper-
ly.
•
Make sure that there is not a damaged fuse in the fuse box.
•
Make sure that the Start/Pause has been pressed.
•
If the delay start is set, cancel the setting or wait for the end of
countdown.
•
Deactivate the Child Lock function if it is on.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low. For
this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
This problem may be caused by the filter of the inlet hose or the
valve drain filter which may be clogged. Refer to "Care and clean-
ing". If problem remains please contact the Authorised Service
Centre.
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the connection of the water inlet hose is correct.
deactivate the appliance.
WARNING! Make sure that the
temperature is more than 0°C before
you use the appliance again. The
manufacturer is not responsible for
damages caused by low temperatures.
- The appliance does not drain the water.
- The appliance lid or drum doors are
open or not closed correctly. Please check
both!
- The mains supply is unstable. Wait until
the mains supply is stable.
- No communication between electronic
elements of the appliance. Switch off and
switch on again.
WARNING! Deactivate the appliance
before you do the checks.
Possible solution
Werbung
Inhaltsverzeichnis
Fehlerbehebung
