Zanussi ZWF 1211 Benutzerhandbuch Seite 11

B
When you use the liquid detergent:
• Do not use gelatinous or thick liq-
uid detergents.
• Do not put more liquid then 120
ml.
• Do not set the delay start.
A
• Measure out the detergent and the fabric condi-
tioner.
• Put the detergent and the fabric conditioner into
the compartments.
• Carefully close the detergent drawer.
ACTIVATING THE APPLIANCE
Press and hold for a couple of seconds the
Ein/Aus Marche/Arrêt button to activate or
deactivate the appliance.
A tune sounds when the appliance is activated.
SETTING A PROGRAMME
1. Touch the programme button
programme:
• The indicator of the button
slowly.
2. If necessary, change the temperature and the
spin speed or add available options. When you
activate an option, the indicator of the set
option comes on.
If you set something incorrect, the
indicator of the button
three times.
2. Adjust the flap in posi-
tion B.
3. Put back the drawer in
the recess.
When the flap is in posi-
tion B and you want to
use powder detergent:
1. Remove the drawer.
2. Adjust the flap in po-
sition A.
3. Put back the drawer
in the recess.
and set the
flashes
flashes red
STARTING A PROGRAMME WITHOUT THE
DELAY START
Touch the button
• The indicator of the button
flash and stays on.
• The programme starts, the door locks, the
indicator
The drain pump can operate for a
short time at the beginning of the
washing cycle.
STARTING A PROGRAMME WITH THE DELAY
START
The start of the programme can be delayed by 9, 6
or 3 hours.
1. Touch the button
want to set.
The indicator of the selected delay is on.
2. Touch the button
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the delay start before you touch the
button . After touching the button
you can only cancel the delay.
To cancel the delay start:
1. Touch the button
pause.
2. Touch the button
set delay goes off.
Touch the button
programme immediately.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Touch .
The indicator of this button flashes.
2. Change the options.
3. Touch again.
The programme continues.
.
stops to
is on.
to choose the delay you
:
to set the appliance to
until the indicator of the
again to start the
11