Cleaning The Detergent Dispenser; Frost Precautions; Troubleshooting - Zanussi ZWF 1210 Benutzerinformation

Cleaning the detergent dispenser

1
3
5
Cleaning the inlet hose and the valve
filter
1
1
2
3

Troubleshooting

WARNING!
Refer to Safety chapters.
Introduction
The start of the appliance does not occur or it
stops during operation.
14
2
4
6
2
3

Frost precautions

If the appliance is installed in an area where the
temperature can be less than 0 °C, remove the
remaining water from the inlet hose and the
drain pump.
Do this procedure also when you
want to do the emergency drain.
1. Disconnect the mains plug from the mains
socket.
2. Remove the water inlet hose.
3. Remove the drain hose from the rear
support and unhook it from sink or spigot.
4. Put the ends of the drain and inlet hose in a
container. Let the water flow out of the
hoses.
5. When no more water flows, install the inlet
hose and the drain hose again.
WARNING!
Make sure that the temperature is
more than 0 °C before you use the
appliance again. The manufacturer is
not responsible for damages caused
by low temperatures.
First try to find a solution to the problem (refer
to the table). If not, contact the Authorised
Service Centre.
With some problems, the acoustic signals
operate. The indicator of button
red and one of the indicators comes on, to
show an alarm code:
4
45°
20°
flashes in
www.zanussi.com