Specifications - Yamaha NS-B310 Bedienungsanleitung

REMOVING THE FRONT
COVER
The front cover is attached to protect the speaker, but you can
remove it if necessary.
The front cover is fixed by magnets. Hold the speaker with one
hand, and pull the front cover gently with the other to remove it.
NS-B310
NS-C310
Notes
• When removing the cover, be careful that you don't touch
the drive units, and don't exert excessive force with any
tools.
• There are magnets on the reverse side of the front cover. Do
not place a front cover close to objects that might be affected
by magnets, such as CRT TV, clock, magnetic card,
diskette, etc., after removing it.
4
En

SPECIFICATIONS

NS-B310
Type .................... full-range acoustic suspension speaker system
Driver .......................................8 cm (3-1/8") cone full-range × 2
Impedance ............................................................................... 6 Ω
Frequency Response ............................ 80 Hz to 35 kHz (-10 dB)
Nominal Input Power........................................................... 40 W
Maximum Input Power ...................................................... 120 W
Sensitivity ........................................................... 87 dB/2.83 V/m
Dimensions (W × H × D)............................ 107 × 200 × 127 mm
Weight............................................................ 1.6 kg (3 lbs. 8 oz.)
NS-C310
Type .......................... 2-way acoustic suspension speaker system
Driver ...................................... 6.5 cm (2-9/16") cone woofer × 4
Impedance ............................................................................... 6 Ω
Frequency Response ........................... 90 Hz to 45 kHz (-10 dB)
Nominal Input Power........................................................... 40 W
Maximum Input Power ..................................................... 120 W
Sensitivity .......................................................... 90 dB/2.83 V/m
Crossover Frequency ......................................................... 6 kHz
Dimensions (W × H × D).............................. 440 × 94 × 125 mm
Weight............................................................ 2.9 kg (6 lbs. 6 oz.)
• Specifications subject to change without notice due to product
improvements.
• Care should be taken not to exceed the input power values noted
above.
• A speaker cable is not included with this model.
Taking care of the speaker
When you wipe this unit, do not use chemical solvents (e.g.,
alcohol or thinners, etc.): this might damage the finish. Use a
clean, dry cloth. For difficult soils, dampen a soft cloth in
water, wring it out, and then wipe with the cloth.
Non-Magnetic shielding type
to 50 kHz (-30 dB)
(4-3/16" × 7-7/8" × 5")
Non-Magnetic shielding type
3 cm (1-3/16") soft dome tweeter
to 100 kHz (-30 dB)
(17-5/16" × 3-11/16" × 4-15/16")