Inhaltsverzeichnis
Werbung
General Specifications (English only)
General Specifications
General
System Type
Frequency Range (-10 dB)
Coverage Angle
Crossover Type
Crossover Frequency
Measured Maximum SPL (Peak)
IEC noise@1m
Transducer
LF
Diameter
Voice coil
Magnet
HF
Diaphragm
Type
Magnet
Enclosure
Material, Color
Floor Monitor Angle
Dimensions (W×H×D, with rubber feet)
Net Weight
Handles
Pole Socket
Rigging Points
Optional Speaker Bracket
Amplifier
Amplifier Type
*1
Power Rating
Dynamic
Continuous
Cooling
AD/DA
HPF
DSP Preset
Protection
Speaker
Amplifier
Power Supply
Connectors
Input
Output
Input Impedance
Input Sensitivity (LEVEL: Maximum)
Input Sensitivity (LEVEL: Center)
Maximum Input Level
Controls
Idle Power Consumption
1/8 Power Consumption
Power Requirements
0 dBu is referenced to 0.775 Vrms.
*1 Power rating (120 V, 25°C). This is total value of individual output power.
This value is measured by releasing the software protection.
Dynamic: Total peak power of individual outputs. Measured at minimum load impedance, with protection released.
Continuous: Measured at nominal impedance, with protection activated.
DHR15
2-way, Bi-amp Powered Speaker, Bass-reflex Type
44 Hz–20 kHz
H90° × V60°
FIR-X tuning (Linear Phase FIR Filter)
1.8 kHz
131 dB SPL
DHR15
15" Cone
2.5"
1.4"
1" Throat Compression Driver
DHR15
—
432 × 692 × 405 mm
24.0 kg
Side × 2
35 mm × 2 (0 and 7 degree)
Top × 2, Rear × 1
(Fit for M10 Eyebolts)
—
DHR15
1000 W (LF: 800 W, HF: 200 W)
465 W (LF: 400 W, HF: 65 W)
D-CONTOUR: FOH/MAIN, MONITOR, OFF
Clip Limiting, Integral Power Protection, DC-fault
Thermal, Output Over Voltage, Output Over Current
Input1: Combo × 1, Input2: Combo × 1, RCA PIN × 2 (Unbalanced)
Output: XLR3-32 × 1 (CH1 Parallel Through or CH1+CH2 Mix)
INPUT1: LINE: 10 kΩ, MIC: 3 kΩ, INPUT2: 10 kΩ
INPUT1: LINE: 0 dBu, MIC: -32 dBu, INPUT2: 0 dBu
INPUT1: LINE: +10 dBu, MIC: -22 dBu, INPUT2: +10 dBu
INPUT1: LINE: +24 dBu, MIC: -8 dBu, INPUT2: +24 dBu
LEVEL × 2, LINE/MIC, HPF, D-CONTOUR, THRU/MIX, POWER
18 W
74 W
100 V, 110–120 V, 220–240 V, 110 V/127 V/220 V (Brazil), 50/60 Hz
DHR12M
55 Hz–20 kHz
H90° × V90°
1.8 kHz
129 dB SPL
DHR12M
12" Cone
2.5"
Ferrite
1.75"
1" Throat Compression Driver
Coaxial
Ferrite
DHR12M
Plywood, Black, Polyurea coating
57°
500 × 343 × 454 mm
16.5 kg
Side × 1
35 mm
—
—
DHR12M
Class-D
Fan Cooling, 4 Speeds.
24 bit 48 kHz Sampling
OFF, 100 Hz, 120 Hz, 24 dB/Oct.
Thermal, Output Over Current
DHR10
52 Hz–20 kHz
H90° × V60° (Rotatable)
1.9 kHz
128 dB SPL
DHR10
10" Cone
2"
1.4"
1" Throat Compression Driver
DHR10
—
305 × 494 × 300 mm
15.0 kg
Top × 1
35 mm
Top × 2, Rear × 1
(Fit for M10 Eyebolts)
UB-DXRDHR10
DHR10
700 W (LF: 500 W, HF: 200 W)
325 W (LF: 260 W, HF: 65 W)
18 W
60 W
131
Werbung
Inhaltsverzeichnis
