Technical Specifications; Replacement Parts And Wearing Parts - Beurer EM 32 Gebrauchsanweisung

― Ensure that no water penetrates into the device. If this should ever happen then only use the device
once it is completely dry.
― Do not use any chemical cleaners or abrasive agents for cleaning.
― Once you have removed the device (operating unit), you can wash the belt in luke warm water. Use mild
soapy water or a liquid detergent for this purpose. Do not use bleaches.
― The belt is unsuitable for machine washing.

8. Technical Specifications

Model:
Power supply:
Electrode size:
Parameter (500 Ohm load):
Pulse duration:
Waveform:
Weight:
Belt size for waist measurement from
Maximum permissible operating conditions:
Maximum permissible storage conditions:
Changes to the technical specifications introduced for reasons of updating without notice are reserved.

9. Replacement parts and wearing parts

Replacement parts and wearing parts are available from the corresponding listed service address under
the stated material number.
Designation
Accessory set
EM 32
3 x 1.5 V AAA (type LR 03)
approx. 11 x 10 cm
– Output voltage max. 70V p-p
– Output current: max. 140mA p-p
– Output frequency: 30 – 80Hz
200µs per phase
symmetrical, dual-phase square wave
~ 240 g (without batteries)
70 to approx. 140 cm. (28 – 55 Inch)
10 °C to +40 °C, 20-65% relative humidity
0 °C to +55 °C, 10-90% relative humidity
Item number and/or order number
647.05
16