Emergency Lowering; Parking Brake Release; After Use Each Day - Upright MX 15/19 Betriebsanleitung

060570-027 MX 15/19
E
M E R G E N C Y
W A R N I N G
!
If the platform should fail to lower, NEVER climb down the elevating assembly.
Stand clear of the elevating assembly while operating the Emergency Lowering Valve Knob.
The Emergency Lowering Valve Knob is located beside
the ladder at the rear of the machine.
1. Open the Emergency Lowering Valve by pulling and
holding the knob.
2. To close, release the knob. The platform will not elevate
if the Emergency Lowering Valve is open.
P
A R K I N G
Perform the following procedure only when the machine
will not operate under its own power and it is necessary to
move the machine, or when winching onto a trailer to
transport.
1. To release the brakes, loosen the jam nut and bolt until
the brakes disengage the tires (Figure 6). The machine will
now roll when pushed or pulled.
2. To re-engage the brakes, tighten the bolt until the brakes
have fully engaged the tires. Secure the bolt with the lock-
nut. Verify that the brakes have fully engaged the rear tires
before operating the machine by testing their ability to hold
the machine on a 25% (14°) grade.
W A R N I N G
!
Never tow faster than 0,3 m/sec. (1 ft./sec.).
Never operate the work platform with the parking brakes released. Serious injury or damage could
result.
A
F T E R
1. Ensure that the platform is fully lowered.
2. Park the machine on a firm level surface, preferably under cover, secure against vandals, children and
unauthorized operation.
3. Turn the Chassis Key Switch to OFF and remove the key to prevent unauthorized operation.
Page 10
L
O W E R I N G
B R
R A K E E L E A S E
Figure 6: Parking Brake Release
U E D
S E A C H A Y
!
!
Figure 5: Emergency Lowering
Emergency Lowering Valve
Knob
Brake Release Bolt
Operation Manual
Operation