Assembly And Installation - Yamaha TT-R125 Handbuch

3
1
2

ASSEMBLY AND INSTALLATION

Throttle grip assembly
NOTE:
Before applying the adhesive, wipe off grease
or oil on the tube guide surface a with a lac-
quer thinner.
Handlebar
5
4
NOTE:
G
G
G
5 - 48
HANDLEBAR
1. Install:
Collar 1
G
Handlebar grip (right) 2
G
Apply the adhesive on the tube guide
3.
1. Install:
Handlebar 1
G
Handlebar holder 2
G
Main switch
G
(TT-R125E/TT-R125LWE) 3
Main switch holder
G
(TT-R125E/TT-R125LWE) 4
Bolt (handlebar holder) 5
G
23 Nm (2.3 m · kg, 17 ft · lb)
Align the punched mark a on the handlebar
with the upper surface of the handlebar
holder on the upper bracket.
The handlebar holder should be installed
with the punched mark b forward.
First tighten the bolts on the front side of the
handlebar holder, and then tighten the bolts
on the rear side.
CHAS