Installing The Unit (In-Dash Mounting); Basic Procedure - Kenwood LW H-A – Serie Bedienungsanleitung

INSTALLATION/CONNECTION
Part list for installation
(A) Faceplate
(C) Mounting sleeve
(E) Extraction key

Basic procedure

1 Remove the key from the ignition switch, then disconnect the [
terminal of the car battery.
2 Install the DAB antenna.
See Installing the DAB antenna. ( 37)
3 Connect the wires properly.
See Wiring connection. ( 35)
4 Install the unit to your car.
See Installing the unit (in-dash mounting).
5 Connect the [ terminal of the car battery.
6 Press to turn on the power.
7 Detach the faceplate and reset the unit within 5 seconds. ( 3)
34
ENGLISH

Installing the unit (in-dash mounting)

(B) Trim plate
(D) Wiring harness
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into
3 Insert the extraction keys deeply into the
Hook on the top side
Orientate the trim plate as
illustrated before fitting.
the holes on both sides of the trim plate,
then pull it out.
slots on each side, then follow the arrows
as shown on the illustration.
Do the required wiring.
( 35)
Dashboard of
your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.