Wiring Connection - Kenwood LW H-A – Serie Bedienungsanleitung

INSTALLATION/CONNECTION

Wiring connection

Connecting the ISO connectors on some VW/Audi or Opel
(Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring harness as
illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function (for ISO connectors)
: Battery
A4 Yellow
Blue/White *
1 : Power control
A5
A7 Red : Ignition (ACC)
A8 Black : Earth (ground) connection
Purple ]
B1
: Rear speaker (right)
For 3-way crossover: Tweeter (right)
Purple/black [
B2
Gray ]
B3
: Front speaker (right)
For 3-way crossover: Mid range speaker (right)
Gray/black [
B4
B5 White ]
: Front speaker (left)
White/black [ For 3-way crossover: Mid range speaker (left)
B6
Green ]
B7
: Rear speaker (left)
For 3-way crossover: Tweeter (left)
Green/black [
B8
Antenna terminal
Ignition wire (Red)
Unit
Battery wire (Yellow)
ISO connectors
Fuse (10 A)
If no connections are made, do not let the wire come out
Yellow (Battery wire)
Red (Ignition wire)
Light blue/yellow
(Steering remote
control wire)
Red (A7)
Blue/White *
(Power control wire/
Antenna control wire)
Yellow (A4)
Brown
(Mute control wire)
NOTE: Total output for Blue/White wire ( *
12 V
If your car does not have an ISO terminal:
We recommend installing the unit with a commercially
available custom wiring harness specific for your car and
leave this job to professionals for your safety. Consult your
car audio dealer.
When connecting to an external amplifier, connect its
ground wire to the car's chassis to avoid damaging the unit.
from the tab.
STEERING WHEEL
REMOTE INPUT
To the steering wheel
REMOTE CONT
remote control adapter
To the power control terminal
2
ANT CONT
when using the optional power
P. CONT
amplifier or to the antenna control
terminal in the vehicle
To connect the Kenwood
navigation system, refer your
MUTE
navigation manual
1
350 mA.
) + ( *
2
) is
35
ENGLISH