Internal Program; Edit Steps For Internal Program - PeakTech 1895 Bedienungsanleitung

6.3. INTERNAL PROGRAM

The power supply has two types of internal program. The first one is a 20 steps program which can be run step by step for some
cycle. The other type is 10 preset programs for quick switch of preset value.

6.3.1. Edit steps for internal program

In "INTERNAL PROGRAM" MENU, select "1. STEPS PROGRAM" then press
1.)
2.) Rotate JOG to show steps you would like to edit.
3.) Press /
4.) Direct key-in value you would like to set. Use
5.) Rotate JOG to current setting area to edit current.
6.) Rotate JOG to duration setting area to edit running duration.
7.) If finish the editing, press
Then press /
8.) If you would like to exit without save the change, press
once, the voltage setting area of the step will be highlighted for edit.
twice to exit. If continuous to edit other step, rotate JOG to highlight voltage setting area.
to move to next / previous step.
for input dot. (e.g. 12.34 press 12
to exit editing.
-44-
to enter the below menu screen.
34).