Touch Controls - Scholtes HP 97 IX Bedienungsanleitung

Operation e Maintenence
Operation
GB
To start the hood (after following all the instructions
described in the previous paragraphs for the
installation and having taken all the safety
precautions), check which type of controls - among
the 2 types indicated below - your hood is provided
with and then follow the relevant directions given.
Push-button controls
The control panel includes:
· 1 "I\0" button to turn the motor on/off
· 3 "I" "II" "III", buttons to adjust the motor speed
(1st - 2nd - 3rd speed)
· 1 " " button to turn the lighting on/off

Touch controls

The control panel includes:
· 1 " " key to turn the motor on/
off
· 1 " " key to reduce the motor
speed
· 1 " " key to increase the
motor speed
· 1 " " display that indicates the
motor speed
· 1 " " key which, once
pressed, turns the motor off
after approximately 12 mins -
when the function is enabled, a
" " dot turns on at the bottom
right-hand side of the " "
display.
· 1 " " key to turn the lighting
on/off
ATTENTION:
Every 30 hours of use the microprocessor, which is
the heart of the system, indicates with a flashing "A"
on the display that the metal grease filters should be
cleaned to consent the exhaust to function better and
improve hygiene in the room. To cancel the warning
message after cleaning the filters, switch off the
hood, press and hold key n°2 for more than 5
seconds. When the key is pressed the letter "A"
appears on the display; after 5 seconds this
disappears and the microprocessor starts a new 30-
hour count-down before displaying the next warning
message.
14
Maintenance
Always make sure you carry out all operations with
the omnipolar switch off, in position O.
A) Cleaning
Clean the external parts of the hood using a soft
cloth and neutral detergent; and avoid using abrasive
powders or brushes. For dirt which is difficult to
remove, you may use methylated spirit. Clean the
steel parts by rubbing in the direction of the surface
finish.
B) Cleaning the Metal Grease Filter
Excess grease particles in the metal filter could
cause an increase in the inflammability of the same;
in order to avoid possible fires, the metal grease filter
should be washed according to how frequently it is
used (in any case every 30 days) in a dishwasher or
in lukewarm water using normal washing up liquid.
After rinsing it and drying it thoroughly, replace the
metal grease filter in its special housing.
C) Lamp Replacement
The hood can be provided with different types of
lamps: incandescent, halogen and neon lamps.
· Halogen lamps (fig. 5 and fig. 6): Figure 5
illustrates the type of lamp with a G4 cap, 20W
power and 12V voltage; to replace it, use a
screwdriver to remove the glass support ring "A"
(fig. 6), then remove the protection glass "B"; pull
out the faulty lamp and replace it with a new one;
then reassemble the protection glass, fastening it
with the corresponding ring.
A
B
Fig. 5
Fig. 6