Operation; Cleaning And Maintenance; Danger To Life; Replacing The Lamp - EuroLite Hexopus base Bedienungsanleitung

OPERATION

Install the device on a plane surface.
Connect the fixture to the mains with the power-plug.
With the ON/OFF-switch, you can switch the device on and off.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the lamp. Maintenance and service operations are
only to be carried out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.

Replacing the lamp

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need one E-27 (UV) lamp with max. 60W.
During the operation, the lamp reaches temperatures of up to 275° C .

DANGER TO LIFE!

Disconnect from mains before starting maintenance operation!
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
CAUTION!
9/18 51100650_V_2_0_4713.DOC