Kremlin-Rexson AIRLESS 40-25 Betriebsanleitung Seite 45

FLOWMAX ® AIRLESS PUMP
Captions :
intensive™ or FLOWMAX  pump (B + C)
A
B
Air motor
C
Fluid section
D
"MOTOR AIR" air regulator
E
Gauge
H
Air inlet valve
I
Ground
J
Relief valve
(For specific installation, please contact your KREMLIN REXSON representative).
Nota : If the pump is equipped with an accumulator filter (M), the filter is supplied with a screen n° 12
(filtration size : 280 µ or 55 mesh). The screen is recommended for the use of an AIRLESS ® gun fitted
with a nozzle model 20. If the fluid spraying is carried out by means of an other nozzle, please choose an
other screen (refer to filter instruction manual).Adjust the screen to the application.
Start up procedure :
1 - Ground the pump.
2 - If the pump is a intensive™ one, fill up the wetting-cup (S) with "T" lubricant (R) or with
an appropriate solvent.
3 - Unscrew the air regulator (D).
4 - Interconnect the equipment with the air pressure network (clean air - P< 6 bar / 87 psi). Install a
water drop, model 3/4" if it is necessary.
5 - Connect all the hoses , compressed air general supply hose and fluid hose (P), as well as the
gun (Q).
Nota : Comply with the diameters of hoses recommended in the specifications of the pump.
6 - Remove the nozzle from the gun.
KREMLIN REXSON
I
Q
M
P
N
O
L Suction rod (depending on version)
M Accumulator filter (depending on version)
N Air shut off valve (depending on version)
O Air shut off rod (depending on version)
P HP Fluid hose
Q Gun
R T lubricant (1/4 l / 8.82 oz)
(only for intensive™ pump)
S Wetting-cup
(only for intensive™ pump)
- 2 - N° : 578.029.120-UK-1106
B
D
E
J
H
C
L