Tips On Energy Saving; Frost Protection - Siemens CT636LES6 Gebrauchsanleitung

en

Tips on energy saving

■ Pour lukewarm water into the empty
water tank up to the "05 l" mark and
then dissolve one Siemens descaling
tablet TZ80002 in it For the TZ60002 you
should always dissolve two tablets
F
If there is not enough descaling
solution in the water tank, you will
be asked to do the following. Refill
using uncarbonated water and press
C again
■ Remove the suction pipe from milk
container, wipe it and insert the end of the
suction pipe into the hole on the coffee
grounds container
■ Close the appliance door
■ Place a container with a capacity of
05 litre under the beverage outlet
■ Press button C
The programme will now run for about
19 minutes
■ Remove the container and press
C
■ Rinse the water tank and (if removed)
replace the water filter.
■ Fill the tank with fresh water up to the
"max" indicator
■ Replace the water tank and close the
door
■ Place the container underneath the
beverage outlet again
■ Press button C
The programme will now run for about
7 minutes and rinse the appliance
■ Remove the container, empty the drip
trays, replace and close the appliance
door
■ Press C The appliance is des-
caled, cleaned and ready for use again
■ Press E to exit the program
Special rinsing
F
Important: If any of the service
programmes is ever interrupted, for
instance by a power failure, please
proceed according to the information
on the display:
■ Rinse the water tank and refill it with fresh
water up to the "max" mark
56
■ Press button C The pro-
gramme will now run for about 2 minutes
and rinse the appliance
■ Empty the drip trays, replace and close
the appliance door The appliance is
ready for use again
■ Press E to exit the program
Tips on energy saving
■ Press button I to switch the
appliance to "energy saving mode" The
appliances uses very little power when
in "energy saving mode", but monitors all
safety-relevant functions so as to avoid
damage
■ In the menu under "Switch off after",
set the automatic switch off period to
15 minutes
■ Reduce the brightness of the display
and the illumination in the menu to save
energy
■ If possible, do not interrupt the dispensing
of coffee or milk froth Stopping a process
prematurely results in higher energy
consumption and the drip tray fills up
more quickly
■ Descale the appliance regularly to avoid a
build-up of limescale Limescale residues
cause higher energy consumption

Frost protection

To prevent frost damage during trans-
port and storage, completely empty the
appliance beforehand (see the section
"Menu – Frost protection")