Tips On Energy Saving; Frost Protection - Siemens TE603 Serie Gebrauchsanleitung

en
● Place the end of the suction pipe 4d in
the container.
● Touch C.
The descaling programme will now run for
about 28 minutes.
If there is not enough descaling solu-
F
tion in the water tank 5, you will see
the prompt Refill descaler ¢start.
● Add more descaling solution and then
touch C again.
● Rinse the water tank 5 and refill it with
fresh water up to the "max" mark.
● If you use a filter, replace it now.
● Touch C.
The descaling programme will now run
for about one more minute, and then the
cleaning programme will run for about
7 minutes and rinse the appliance.
● Empty and re-insert the drip tray 17.
F Important: Wipe over the appliance
with a soft damp cloth to ensure that
you immediately remove any traces
of descaling solution. It is possible for
corrosion to form underneath such
deposits. New sponge cloths may
contain salts that can cause rust films
to form on stainless steel, so such
cloths should always be thoroughly
rinsed before use. Clean the suction
pipe 4d of the drinks outlet particu-
larly carefully.
The appliance has finished descaling and is
ready for use again.
Important: If any of the service
F
programmes is ever interrupted, for
instance by a power failure, please
proceed as follows:
● Rinse the water tank 5 and refill it with
fresh water up to the "max" mark.
● Touch C.
46
All manuals and user guides at all-guides.com
The appliance will be rinsed for approx.
2 minutes for safety reasons.
● Empty and re-insert the drip tray 17.
The aborted service programme must
be restarted.

Tips on energy saving

● When the fully automatic coffee machine
● In the menu, set the Automatic shut-down
● If possible, do not interrupt the dispensing
● Descale the appliance regularly to avoid a

Frost protection

F
See the section "Menu – Frost protection".
is not in use, use the mains switch J 1 on
the front of the appliance to switch it off.
period to 15 minutes.
of coffee or milk froth. Stopping a process
prematurely results in higher energy
consumption and the drip tray fills up
more quickly.
build-up of limescale. Limescale residues
cause higher energy consumption.
Caution!
To prevent frost damage during trans-
portation and storage, completely
empty the appliance beforehand.