Pkm WA5-E1008 Bedienungsanleitung Seite 40

1. Disconnect the appliance from the mains.
2. Wash the tap with warm water so you can take the inlet hose off.
3. Take off the hose and immerse it in warm water.
4. Pour warm water into the drum and wait approx. 10 minutes.
5. Reconnect the inlet hose to the tap and check, that the water inlet and the
water drain works properly.
6. When you operate the appliance again, the ambient temperature has to be
0
higher than 0
If you have installed the appliance in a place, where the ambient temperature
can easily fall below 0
How to remove residual water in the inlet hose:
1. Close the water tap.
2. Remove the inlet hose from the tap and put the end into a container.
3. Start a programme. Now the water is being drained for approx. 40 seconds.
4. Connect the hose again.
CAUTION! Wait until the hot water has cooled down.
1. Press the arrow on the softener cover downwards.
2. Lift the clip, take out the cover and clean the rills
with water.
3. Reinstall the cover and push the container back in its
proper position.
The filter has to be cleaned, when it is not or improperly supplied with water with
1. Close the water tap.
2. Choose a programme.
3. Press START/PAUSE and keep the following
operation running for 40 seconds.
4. Disconnect the inlet hose from the tap.
5. Wash the filter with water.
6. Connect the hose to the tap.
C.
Frost protection
0
C, always empty the inlet and outlet hoses.
Remove residual water in the drain pump.
Cleaning of the detergent container
Cleaning of the water inlet filter
the tap opened.
40