Opening The Door; End Of Cycle - AEG LP 5280 Benutzerhandbuch

18 www.aeg.com
10.11 Cancelling a running
programme
1. Press button Ein/Aus - Marche/Arrêt
to cancel the programme and to
deactivate the appliance.
2. Press button Ein/Aus - Marche/Arrêt
again to activate the appliance.
Now, you can set a new washing
programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.

10.12 Opening the door

If the temperature and level
of the water in the drum are
too high and the drum still
rotates you cannot open the
door.
While a programme or the delay start
operates, the appliance door is locked.
1. Press button Start/Pause - Départ/
Pause.
In the display the related door lock
indicator goes off.
2. Open the appliance door.
3. Close the door and press button
Start/Pause - Départ/Pause.
The programme or the delay start
continues.

10.13 End of cycle

When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display
locked indicator
The indicator of Start/Pause - Départ/
Pause button goes off.
1. Press button Ein/Aus - Marche/Arrêt
to deactivate the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
comes on and the door
goes off.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent
mildew and odours
10.14 Draining water out after
end of cycle
The washing programme is completed,
but there is water in the drum:
The drum turns regularly to prevent the
creases in the laundry.
The door lock indicator
door stays locked.
You must drain the water to open the
door:
1. If necessary, decrease the spin
speed.
2. Press the Start/Pause - Départ/Pause
button.
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator
off, you can open the door .
4. Press Ein/Aus - Marche/Arrêt some
seconds to deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.
10.15 AUTO Stand-by option
The AUTO Stand-by function
automatically deactivates the appliance
to decrease the energy consumption
when:
• You do not use the appliance for 5
minutes before you press Start/Pause
- Départ/Pause button.
Press the button Ein/Aus - Marche/
Arrêt to activate the appliance again.
• After 5 minutes from the end of the
washing programme
is on. The
goes