Options - AEG LP 5280 Benutzerhandbuch

14 www.aeg.com
7.2 Child Lock
With this option you can prevent that the
children play with the control panel.
• To activate/deactivate this option,
press Temp. and U./Min. - T/Min. at
the same time until the indicator
comes on/goes off.
You can activate this option:
• After you press Start/Pause - Départ/
Pause : the options and the
programme knob are locked.
• Before you press Start/Pause -
Départ/Pause : the appliance cannot
start.

8. OPTIONS

8.1 Programme knob
Turn this knob to set a programme. The
related programme indicator comes on.
8.2 Start/Pause - Départ/Pause
Press button Start/Pause - Départ/Pause
to start or interrupt a programme.
8.3 Zeitvorwahl - Départ
Différé
With this option you can delay the start
of a programme from 30 minutes to 20
hours.
The display shows the related indicator
and delay time.
8.4 Zeit Sparen - Gain de
Temps
With this option you can decrease the
programme duration.
• Press this button one time to set
'Shortened duration' for items with
daily soil.
• Press this button two times to set
'Extra Quick' for items with almost no
soil.
Some programmes accept
only one of the two options.
7.3 Permanent Extra Rinse
With this option you can permanently
have an extra rinse when you set a new
programme.
• To activate/deactivate this option
press Zeit Sparen - Gain de Temps
and Zeitvorwahl - Départ Différé at
the same time until the indicator Extra
Spülen - Rinçage + comes on/goes
off.
8.5 Extra Spülen - Rinçage +
With this option you can add some rinses
to a washing programme.
Use this option for persons allergic to
detergents and in areas where the water
is soft.
The related indicator comes on.
8.6 Flecken - Taches
Set this option to add the stain phase to
a programme.
Use this option for laundry with hard
stains to remove.
When you set this function, put the stain
remover into compartment
This option increases the
programme duration.
This option is not available
with a temperature lower
than 40 °C.
8.7 U./Min. - T/Min.
With this option you can decrease the
default spin speed.
The display shows the indicator of the set
speed.
Additional spin options:
No Spin
• Set this option to remove all spin
phases.
.