Master/Slave-Operation; Dmx-Controlled Operation - EuroLite LED STL-50F 5600K Bedienungsanleitung

Dimmer curves (8 types):
Dimming Curves options:
Linear
LINEAR: the increase in light intensity appear to be linear as DMX value is increased.
SQUARE LAW: light intensity control is finer at low levels and coarser at high levels
INVERSE SQUARE LAW: light intensity control is coarser at low levels and finer at high levels
S-CURVE: light intensity control is fine at low levels and high levels and coarser at medium levels.
The dimmer curves described above are available in two different versions – with the response
characteristics of halogen lamps (dimmer curve 01 – 04) and response characteristics of LEDs (dimmer
curve 05 – 08).

Master/Slave-operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear of the LED STL-50F 5600K studio lamp you can find an XLR-jack (DMX Out) and an XLR-plug
(DMX In), which can be used for connecting several devices.
Choose the device which is to control the effects. Set the desired Master-mode on the master-device. This
device then works as master-device and controls all other slave-devices, which are to be connected to the
master-device via a balanced microphone lead. Connect the DMX out connectors with the DMX input plug of
the next device.
Set the Slave-mode on every slave-device.

DMX-controlled operation

The device has 2 DMX-modes. The Control Board allows you, as described above, to assign the DMX-Mode.
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED STL-50F 5600K studio lamp will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each LED STL-50F 5600K
studio lamp correctly and independently from any other fixture on the DMX-chain. If several LED STL-50F
5600K studio lamp are addressed similarly, they will work synchronically.
If you set, for example, the address to channel 4, the device will use the channel 4 to 6 for control.
Controlling:
After having addressed the LED STL-50F 5600K studio lamp, you may now start operating it via your lighting
controller.
Note: It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order
to ensure proper transmission on the DMX data link.
Press the MODE button until the display shows DIMMER.
Press the ENTER button. You can select the dimmer
CURVE: 01-08 via the UP or DOWN buttons (s.
illustration). Confirm your choice by pressing ENTER.
23/26 00065291, Version 1.1