Herunterladen Inhalt Inhalt Diese Seite drucken

Sound Mode; Master/Slave Mode; Dmx Mode - EuroLite LED PST-15W QCL Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für LED PST-15W QCL:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Program:
P 1
P 2
To set the desired program speed, press the MODE button until the LED display shows "S---". The desired
speed (s001 - s100, increasing) can be selected via the UP or DOWN buttons.
Please press the ENTER button to confirm.

Sound Mode

Press the MODE button until the LED display shows "snd", then please press the ENTER button to confirm.

Master/Slave Mode

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the Master device to one of the stand alone modes ("C---" or "P---") and set each Slave device to the
same DMX address "d001".

DMX Mode

DMX Channel Selection: Choosing a DMX Channel Mode
Before setting the desired DMX address(es), you must choose a DMX Channel Mode (6 CH or 8 CH) via the
MODE button.
Press the ENTER button again to confirm.
Please see the following DMX protocol graphics for the respective channel values.
Addressing
The LED display allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED PST-15W QCL DMX Spot will respond to the controller.
Press the MODE button until the display shows "512" then press the ENTER button to confirm.
Set the desired address via the UP or DOWN buttons (d001 - d512).
Please press the ENTER button again to confirm.
Controlling:
After having addressed the LED PST-15W QCL DMX Spot, you may now start operating it via your lighting
controller.
Note: It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order
to ensure proper transmission on the DMX data link.
Function:
Fading colors
Switching colors
21/23
00065717.DOC, Version 1.1

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis