Maintenance - DeWalt DW755 Originalanweisungen

EN GLI SH
Switching On and Off (fi g. 1)
To turn the tool on, set the on/off switch (a) to
position 1.
To turn the tool off, set the on/off switch (a) to
position 0.
Using the Grinding Wheel (fi g. 1)
In order to achieve a straight cutting edge, move it
slowly backwards and forwards over the grinding
wheel (b). Only exert a light pressure.
Using the Clamping and Grinding
Attachment (fi g. 14)
1. Insert the workpiece into the clamping
bracket (v v).
2. Position the workpiece as required to obtain the
correct bevel angle. The angle is a function of
the protruding length X (see figure). For plane
irons, X should be approx. 20 mm, for chisels
approx. 25–28 mm.
3. Tighten the star knobs (ww).
Using the Grinding or Honing Belt
(fi g. 15)
1. Hold the cutting edge of the workpiece in the
direction of rotation as indicated by the arrow (u)
on the machine.
2. Move the workpiece backwards and forwards
over the belt.
Grinding can be done at three different points on the
grinding or honing belt (e).
• Use the area (A) over the large belt pulley (xx)
or the area (B) over the backing plate (r) for
preliminary grinding.
• Use the unsupported area (C) for finishing, as it
will mould itself to the shape of the workpiece.
Using the water supply system
(fi g. 13)
1. Unscrew the cap (uu).
2. Adjust the water flow as required using the flow
regulator (tt).
WARNING: Depending on the
workpiece material, the water may be
contaminated. Keep out of reach of
children.
WARNING: When the water collector is
full, it must be emptied. Dispose of the
water in an environmentally safe way.
34

MAINTENANCE

Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the switch is in the OFF position. An
accidental start-up can cause injury.
On a weekly basis, remove grindings from the
housing and the covers.
Putting the Machine Out of Operation
If the machine is put out of use for a longer period of
time, remove the honing belt from the machine and
store it in a dry and safe place.
To remove the belt, refer to the instructions for
Changing the Grinding or Honing Belt.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.