Using The Tap; Operation; Child Safety Lock; Sleep Mode - clage Zip HydroTap Montageanleitung

5. Using the Tap

Dispense Dispense
boiling water cold water

Child safety lock

Note: If the Zip HydroTap ® MINIBOIL has not been used for several days, allow
the tap to run ambient water for about one minute.

Operation

Press the red lever and the Safety button to dispense boiling water. Pull the lever up
while holding the safety button to dispense boiling water continually. The water will
flow for about 15 seconds. Then manually return the lever to the off position.
Press the blue lever to dispense ambient water. Pull the lever up to dispense ambient
water continually. The water will flow for about 15 seconds. Then manually return the
lever to the off position.
Red LED: boiling water
• Steady light: boiling water is ready and can be dispensed.
• Flashing: the water temperature is below the set value. Boiling water cannot be
dispensed.
• Flashing slowly: the unit is in Sleep mode.
Blue LED: Cold water
• Steady light: filtered cold water can be dispensed.
White LED: filter
• Flashing: the filter needs to be replaced. This LED will start flashing either after
12 months of use or after 4,000 litres of water have been filtered, whichever is
earlier.
All LEDs: fault
• Flashing: there is a fault in the unit. In that case, switch off the unit for at least
15 minutes. If the fault has not been corrected when the unit is switched on again,
contact customer service.
Child safety lock
A child safety lock is enabled to prevent boiling water flowing out of the tap if the
boiling water control is accidentally operated. To draw boiling water, the Safety button
has to be pressed and held down at the same time as the red lever.

Sleep mode

The unit can be set to Sleep mode to save energy. If Sleep mode is enabled, the unit
will switch to Sleep if it has not been used for two hours. The water temperature will
be maintained at 64 °C. Operation of the tap during this time will wake the system
from sleep and the water will start heating up again. Boiling water is available as soon
as the red LED shows a steady light.
Press the blue lever and the Safety button and hold them for about 5 seconds to enable
or disable Sleep mode.
The red LED and the white LED will flash simultaneously to confirm that Sleep is
enabled. They will flash alternately to confirm that Sleep is disabled.
19
CLAGE
EN