Safety; Export - SOLTRON XL-70 Turbo Plus Gebrauchsanweisung

Please read and observe ...

Safety

Danger!
Assembly and electrical connection must comply with the
1)
national regulations.
The electrical installation must be fitted with a separator
(switch) by the customer (contact distance > 3 mm). If the
connection is via a plug connection, then the system must
conform to the requirements of the local electrical
regulations;5-pole 400 VAC (16A or 32A).
Assembly, installation, upgrading or repair of the device may
only be carried out by specially trained and instructed
personnel.
• All danger and safety notes attached to the device must be observed!
• No safety equipment (e.g. panel switch) or safety notes may be
removed or deactivated which can impair the safe operation of the
device!
• The device may only be operated in proper condition!
• A timing device must be designed so that the device is automatically
switched off at the latest after 110% of the selected operating time
even when the controller fails. The device operating time must be
dual controlled with a timing device to the standards EN 60335-2-27
and A1 2000 Section 22.108 and 22.109.
• Do not change, obstruct or block the air inflow and outflow area to the
device or make any unauthorised changes to the device. The
1) In Germany: VDE regulations
36
manufacturer shall bear no liability for damage or injuries resulting
from such actions.
• The appliance must not be installed and operated on the shipping
pallet! There is a danger of overheating due to the airflow being
obstructed.
Caution!
The code for access via the infrared interface is preset in the
software of the hand-held unit, and can therefore be used with
any unit. Anyone, who downloads the software from the Inter-
net can access the unit date with a hand-held unit. Please note
that Customer Service changes the preset access code during
initial start-up – see Page 117. Please note the new code for
future use!
This code is independent of the access code for the preset-
tings via the control panel.

Export

We emphasise that these devices are intended for the European market
and must not be exported to nor operated in the USA or Canada!
The manufacturer shall assume no liability whatsoever in case of non-
observance! We explicitly emphasise that high liability risks may occur
for the exporter an/or the operator in case of non-observance.